Trampoline with lacing

Estimated reading time: < 1 min

Materials

[one_third]

Trampoline rear lace: 3mm, 4.5m, black

[/one_third]

[two_third_last]

F16 trampoline with lacing loops

[/two_third_last]

Tools needed:
– Long nose plier

Steps

1. Unscrew a beamcap on one side. Then slide the front side of the trampoline into the designated slot. The hiking straps should be facing up.

2. Make sure the trampoline is positioned in the middle of the catamaran.

3. Insert the trampoline tie-rod into the sleeve on the rear of the trampoline.

4. Loop the rear lacing line through the tie-rod, as shown in the picture below. Start at the port side of the trampoline With a bowline knot.

Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Previous: Front crossbar(beam) pre-bend
Next: Trampoline tensioning lacing
Scroll to Top