Trapeze wires: Can’t miss version

Estimated reading time: 1 min

[one_half]

Trapeze rings and blocks “can’t miss” (31174)

[/one_half][one_half_last]

4x Trapeze line: 5mm, 1.2m, grey

[/one_half_last]


Steps:

1. Lace one end of the line through both holes of the stop block.
2. Then over the middle of the block and through the loop just created.
3. Feed the line back through the same loop but don’t pull it through entirely. This should leave a loop.
4. Tie the used end of the rope off with a figure 8 knot.

Front of stop block
The rear of the stop block

5. Feed the free end of the line through the eye in the trapeze wire.
6. Tie this end to the metal part of the can’t miss trapeze ring using an overhand knot.
7. Tie the line off with a figure 8 knot.

 

Next topic

Beam assembly threaded

Front crossbar(beam) pre-bend

Bridle with connector

Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Previous: Trapeze wires steel or Dyneema installation
Next: Trapeze wires: Adjustable trapeze version
Scroll to Top