Search
Close this search box.

Shroud attachment (Staymaster)

Estimated reading time: < 1 min

Tools needed:
– Wrench 11mm or 7/16 inch

Steps:

1. Slide the retainer ring down to unlock.

2. Lengthen the staymaster to the maximal length by turning the nut.

3. Connect the staymaster to the stay pin on the port hull and side using the bolt and nut. Make sure the bolt and nut are not tightened fully to allow the staymaster to move.

4. Slide the retainer ring around the nut and repeat steps for the starboard side.

Applicable to boats:
Was this article helpful?
Dislike 1

Continue reading

Previous: Fixing the stays
Scroll to Top