Beam assembly threaded

Estimated reading time: 1 min

[one_third]

8x Bolt crossbar front UNC 3/8 x 4.1/2 socket (30360)

[/one_third][one_third]

1x Hull starboard

[/one_third][one_third_last]

1x Hull port

[/one_third_last]

[one_third]

8x Washer fiberglass (31113)

[/one_third][one_third]

8x Washer stainless steel (31117)

[/one_third][one_third_last]

Rear crossbar

[/one_third_last][one_third]

Front crossbar

[/one_third][one_third]

Stern support (30917)

[/one_third][one_third_last]

EuroTrax launching trolley

[/one_third_last]

Required tools:

– Torque wrench
– 5/16 or 8 mm Allen key
– Grease

End result

 

 


Steps

1.


2.

Take time to align the crossbars !

3.

 

 

 

 


4.

Do not exceed the recommended 30 Nm, over-tightening the bolts results in damaged threads.


5.

 

 

 

 


6.

Do not exceed the recommended 30 Nm, over-tightening the bolts results in damaged threads.

 

 

 

 

Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Next: Front crossbar(beam) pre-bend
Scroll to Top