Search
Close this search box.
Search
Close this search box.

Bridle with connector

Estimated reading time: < 1 min

500MK2 only

Tools needed:
– Allen tool size 3
– Wrench 11mm

Steps:

1. Mount the bridle wires on the bridle connector. Use the clevis pins 1/2 x 1/4.


2. Connect the bridles to the bridle pins.

If you are installing a spinnaker kit also do the following steps.

3. For a snuffer system: Install the ring 3×20 ss under the fork terminal on the port side as shown in the picture.

4. For the 500MK2: Install bowsprit connector plates on both bridle terminals.

Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Previous: Trampoline tensioning side cable
Next: Righting line
Scroll to Top