Jib sheet self-tacking non-continuous

Estimated reading time: 1 min

[one_half]

16mm single block Harken (30647)

[/one_half]

[one_half_last]

Jib sheet big: 6mm, 8m, grey

[/one_half_last]


Steps:

1. Fixate the jib sheet big line on the starboard side in the front beam cam cleat.

2. Slide the 16mm block on the jib sheet big.
3. Thread the jib sheet big through the port side front crossbar cam cleat.
4. Take the mouse-line from the lower rear eye in the Front beam endcap.
5. Attach the jib sheet big to the shock cord using a figure-eight knot.

6. When both sides of the jib sheet are attached to their shock cords in the beam the mouse-line can be removed.

 

Next topic
Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Previous: Jib Halyard
Scroll to Top