Press Ctrl/Cmd + P to print
or save as PDF

Trampoline groove in hull

Tools needed:
Long nose plier

1. Slide the front of the trampoline into the track of the front beam. The front top has a pocket opening in the middle. Check if the top points upwards.

2. Make sure the trampoline is centered.

3. Ideally with two persons, slowly and evenly pull the sides into the tracks on the hulls.

Check if the trampoline does not get stuck at the front edge of the track. Pulling hard when this happens can damage your trampoline.
Pulling the trampoline in can be heavy, but this becomes easier over time when the trampoline stretches a bit. You can use soap on the sides of the trampoline to lubricate it.

4. Insert the trampoline tie rod into the trampoline.

5. Make a small bowline in the port end of the rope.

6. Loop the rope through the tie rod from top to bottom, port to starboard.