Search
Close this search box.

Trapeze wires: Standard hook

Estimated reading time: < 1 min

1. Lace one end of the line through both holes of the stop block.

2. Then over the middle of the block and through the loop just created.

3. Feed the line back through the same loop but don’t pull it through entirely. This should leave a loop.

4. Tie the used end of the rope with a figure 8 knot.

5. Feed the free end of the line through the eye in the trapeze wire.

6. Tie the same end to the smaller trapeze ring using an overhand knot.

7. Tie the line off with a figure 8 knot.

Applicable to boats:
Was this article helpful?
Dislike 0

Continue reading

Previous: Trapeze wires Dyneema installation
Next: Trapeze wires: Can’t miss version
Scroll to Top