-
Traveler System Split Tail
-
Estimated reading time: < 1 min
-
Required items
- Fully assembled mainsheet
Steps
-
1. Make a knot in the mainsheet.
-
2. Feed the split end through the traveler car as shown in the picture.
-
3. Make sure the line splits after passing through the traveler’s car.
-
4. Knot the ends to the strap eyes. Make sure the traveler’s car is in the middle of the rear crossbar.
-
5. Move the traveler car to the side, a few centimeters away from the red traveler stop, and replace the knot from step 1 towards the cleat on the traveler, making sure the car is not able to hit the (security) end stop.
-
6. Attach the mainsheet blocks to the traveler’s eyelet.
Applicable to the following boats: