-
Beam Assembly Bolt & Nut
-
Estimated reading time: < 1 min
-
Requirements
Steps
-
1. Space the hulls approximately 2.5m parallel from each other. Use cardboard cradles or cattrax to support the hulls.
-
2. Place both crossbars
-
3. Insert all beam bolts before tensioning. Grease the bolts using the supplied grease.
-
Do not use sikaflex to make the holes watertight! You can use a less strong silicone-based kit.
-
4. Put the nuts on the bolts from the inside via the hatches.
-
5. you can use the supplied 8mm Allen key to tension the bolts.
-
-
Do not exceed the recommended 30 Nm, over-tightening the bolts results in damaged threads!
