-
Trampoline Grooves in Hull
-
Estimated reading time: < 1 min
-
Requirements
-
Trampoline -
3mm Lacing line -
6mm Tie Rod
-
Tools needed
- Longnosed pliers
Steps
-
1. Slide the front of the trampoline into the track of the front beam. The front top has a pocket opening in the middle. Check if the top points upwards.
-
2. Make sure the trampoline is centered.
-
3. Ideally with two persons, slowly and evenly pull the sides into the tracks on the hulls.
-
Check if the trampoline does not get stuck at the front edge of the track. Pulling hard when this happens can damage your trampoline.
-
Pulling the trampoline in can be heavy, but this becomes easier over time when the trampoline stretches a bit. You can use soap on the sides of the trampoline to lubricate it.
-
4. Insert the trampoline tie rod into the trampoline.
-
5. Make a small bowline in the port end of the rope.
-
6. Loop the rope through the tie rod from top to bottom, port to starboard.
