-
Trampoline Wing with Plate
-
Estimated reading time: < 1 min
-
Requirements
-
Wing Trampoline -
Wing Plate -
3mm Lacing line -
6mm Tie Rod
-
Tools needed
- Longnosed pliers
-
ONLY on F18 Evolution MK I - Serial numbers up to 45. Find the number on the starboard stern.
Steps
-
1. Un-install the self-tacking jib track from the front crossbar.
-
Be aware that the Clevis pins have different dimensions!
-
2. Insert the trampoline plates from the outside into the trampoline slot on the front. Do this on the starboard and port side.
-
-
3. Fixate the trampoline with the trampoline plate on the buttons on the front crossbar. Make sure you bring the two loose flaps between the beam and the dolphin striker.
-
4. The plate needs to be against the front crossbar. Make sure the buttons stick out adequately.
-
5. Wrap the trampoline around the front crossbar. Make sure the six cutouts fit the bases of the self-tacking jib track.
-
6. Insert the trampoline tie-rod into the slot on the rear of the trampoline.
-
7. Loop the rear lacing line through the tie rod, as shown in the picture above. Start at the port side of the trampoline.
-
8. Re-install the self-tacking jib track. Pay attention to the different lengths of the Clevis pins.
-
9. Continue from chapter Trampoline Tensioning Side Lacing.
