-
Spinnaker System: 1 Cleat on Mast External Tack (1-person system)
-
Estimated reading time: 2 min
-
Guiding Template
Steps
Option A: Spinnaker Sheet blocks for Wing Trampoline
-
2x Carbo 40 single/swivel block Harken® (30608)
-
1. Attach the two Carbo 40mm single/swivel blocks to the loops on both sides located at the front of the trampoline (see A).
Option B: Spinnaker Sheet blocks for Non-wing Trampoline
-
2x Carbo 40 single/swivel block Harken® (30608)
-
1. Attach the two Carbo 40mm single/swivel blocks to the eyelets on the starboard and port of the front crossbar.
-
2x Carbo 57 Ratchmatic Harken® (30605)
-
Spinnaker Sheet Block Shock Cord - 3mm, 0.4m, black
-
Spinnaker Sheet Ratchet Block on Hull
-
1. Attach the 57 mm Carbo ratchmatic single spinnaker blocks on the strap eyes on the hull.
2. Tie the spinnakerblock shockcord between the spinnakerblocks.
-
Single Fixed block Asymmetric Carbo 29mm Harken® (30640)
-
Spinnaker Halyard Block Trampoline
-
1. Attach a 29mm carbo single fixed asymmetric block on the middle of the trampoline as shown in B.
-
40mm Carbo Pivoting Lead block
-
Spinnaker Halyard Cleat on the Mast
-
1. Install the 40mm Carbo pivoting lead block. The cleat is facing downwards.
-
Single Fixed block Asymmetric Carbo 29mm Harken® (30640)
-
Spinnaker Sheet Block Shock Cord - 3mm, 2.5m, black
-
Spinnaker Halyard Block Rear Trampoline
-
1. Knot a butterfly hitch in the middle of the shock cord.
2. Attach the carbo 29mm to the loop just created.
3. Feed the shock cord from the top down through the grommets in the rear corners of the trampoline. -
4. Tie the ends off on the rear trampoline lacing.
-
Ring 3x15mm stainless steel -
Spinnaker Trampoline Block tie - 3.5mm, 0.3m, white
-
Spinnaker Halyard Ring Trampoline
-
1. Loop the rope through the two grommets positioned in the front of the trampoline.
2. Then feed it through the ring.
3. Repeat steps 1 and 2, two or three times.
4. Tie the ends of the rope together.