Empowering sailors since 1975
  • Prices for:
  • Jib Cunningham 1:4 Rigging

  • Estimated reading time: 1 min
  • Requirements

  • req-1
    HarkenĀ® Single Block T2 Carbo soft-attach 18mm 31874
  • req-2
    Jib Cunningham short - 3mm, 2.5m, black
  • req-3
    Jib Cunningham long - 3mm, 5.5m, black

Steps

  • 1. Use the two jib Cunningham lines and the 18mm T2 block.

  • 2. Feed the one end of the jib Cunningham line (long) through the small clamcleat.

  • 3. Feed the other end of the line through the bullet sheave located on the dolphin striker rod underneath the front beam.

  • 4. Feed it through the T2 18mm block, return through the bullet sheaves.

  • 5. Feed the line through the clamcleat.

  • 6. Knot the jib Cunningham line (short) with a bowline to the T2 18mm block.

  • 7. Feed the line through the cheek block (from bottom to top).

  • 8. Thread the line through the tack eye of the jib.

  • 1-jib-cunningham-1-4

    9. Tie the line off to the bowsprit.