-
Bridle with Ring
-
Estimated reading time: < 1 min
-
Requirements
-
Tools needed
- Wrench 17mm
- Longnosed pliers
- Grease
- Self-amalgamating tape
-
It is preferable to place the mast on supports while building the mast.
-
The brass fitting is asymmetric. Make sure the brass fitting is in the same position as shown in the pictures!
Steps
-
1. Mount the bridle wires on the bridle ring. Use the clevis pins 1/2 x 1/4.
-
2. Wrap the rope around tightly around the ring.
-
3. Connect the bridle to the bridle pins.
-
If you are installing a spinnaker kit, continue to step 4.
-
4. Install the ring 3×20 ss under the fork terminal on the port side as shown in the picture.
