-
Bridle with Connector
-
Estimated reading time: < 1 min
-
Requirements
-
-
FOR USE ON Nacra 500MK2 ONLY
-
Tools needed
- Wrench 11mm
- Allen tool size 3
Steps
-
1. Mount the bridle wires on the bridle connector. Use the clevis pins 1/2 x 1/4.
-
2. Connect the bridles to the bridle pins.
-
If you are installing a spinnaker kit, continue to step 4.
-
3. For a snuffer system: Install the ring 3×20 ss under the fork terminal on the port side as shown in the picture.
-
This step is only for use on Nacra 500MK2.
-
4. For the 500MK2: Install bowsprit connector plates on both bridle terminals.
