-
Kick-up Rudders
-
Estimated reading time: 1 min
-
Requirements
-
Tools needed
- Wrench 7/16 or 11mm
- Flat screwdriver
- Grease
- Adjustable spanner
Steps
-
1. Assemble the upper and lower casting on the rudder blade. Use a flat screwdriver and grease.
-
2. Use the self-locking slot for the nylock nut at the port side of the casting.
-
3. Put the boat on a high support or a trailer to align the rudders high enough to lock down the rudders.
-
4. First place the lower pin through the lower casting.
-
5. Put the top pin through the lower casting.
-
6. Push the casting all the way down and check if the retainer clip is over the casting.
-
7. Lower the blades and lock both systems.
-
8. Take the Philips screw out of the tiller arm.
-
9. Place the tiller crossbar in between the arms. The following two chapters will explain how to mount it on the tiller arms correctly.
-
10. Check if the connector for the tiller extension is on top.
-
Correct orientation
-
Wrong orientation!