-
Jib Sheet Self Tacking Continuous (cleats on beam)
-
Estimated reading time: < 1 min
-
Requirements
-
16mm block -
5mm jib sheet big
Steps
-
1. Fixate the jibsheet big line on the starboard side in the front crossbar clam cleat.
-
2. Slide the 16mm block on the jibsheet big.
-
3. Thread the jibsheet big through the port side front crossbar clam cleat.
-
4. On port side, un-knot (from the small clam cleat) the rear pre-installed mouseline in the front crossbar, and attach it on the jibsheet big.
-
5. On starboard side, pull the jibsheet big with the mouseline through the internal system until it comes out of the front crossbar.
-
Watch out for the tension on the mouseline. It can slip inside the beam.
-
-
6. Attach the two ends of the jib sheet big together.
-
7. When both sides of the jibsheet are attached to eachother, mouseline can be removed.
-
If the mouseline accidentally slips into the front crossbar take a close look at the drawing of the internal system.
