-
Jib Sheet Self Tacking Non-continuous
-
Estimated reading time: < 1 min
-
Requirements
-
16mm single block Harken® (30647) -
Jib sheet big - 6mm, 8m, grey
Steps
-
1. Fixate the jib sheet big line on the starboard side in the front beam clam cleat.
-
2. Slide the 16mm block on the jib sheet big.
-
3. Thread the jib sheet big through the port side front crossbar clam cleat.
-
4. Take the mouse-line from the lower rear eye in the front beam endcap.
-
5. Attach the jib sheet big to the shock cord using a figure-eight knot.
-
6. When both sides of the jib sheet are attached to their shock cords in the beam the mouse-line can be removed.
