-
Trapeze Wires - 'Can't-miss' Version
-
Estimated reading time: 1 min
-
Requirements
-
Trapeze rings and blocks “Can’t miss” (31174) -
4x Trapeze line - 5mm, 1.2m, grey
Steps
-
1. Lace one end of the line through both holes of the stop block.
-
2. Then over the middle of the block and through the loop just created.
-
3. Feed the line back through the same loop but don’t pull it through entirely. This should leave a loop.
-
4. Tie the used end of the rope off with a figure 8 knot.
-
-
5. Feed the free end of the line through the eye in the trapeze wire.
-
6. Tie this end to the metal part of the can’t miss trapeze ring using an overhand knot.
-
7. Tie the line off with a figure 8 knot.
-
