Search
Close this search box.
Search
Close this search box.

Jib Halyard

Estimated reading time: < 1 min

Steps:

1. Use the 5 mm jib halyard line and feed it through the teardrop eye of the installed forestay.

2. Both ends go through the ring at the forestay. Check if the ring is facing inwards.


3. Knot one end with a bowline to the eyelet of the S-hook.
4. Attach the other end with two bowlines onto the 1.6mm (short) jib halyard line.
5. The loose end of the short jib halyard needs to be fed through the small hole in the S-hook and secured by a figure 8-Knot.

Applicable to boats:
Was this article helpful?
Dislike 1

Continue reading

Previous: Bridle with shackle and furler
Next: Jib sheet self-tacking non-continuous
Scroll to Top